Remove 2 screws hold teflon space and redrill holes. You will have to put tube in can and see where spacer needs to go. We measured down from top of can 41". The holes were different on each can.
Insert tube and tighten nut. Take shaft and insert from bottom of can and screw it into nut.
TX Notch
Remove coax jumper then loosen barrel connector. Slide wire out of tube.
Cut the tube 17 1/2" with the pl259 pushed in as short as it will go.
Cut center wire at 16"
Take a file and round the end of wire off. Just make sure its smooth. Deburr tube and cut slits in end. Reassemble and install on can.
Extend the threads on shaft down to 36" from bottom of shaft. You can cut the old thread off after you install it back in the can. We cut the shaft at 60" but it makes it kind of hard to install back in can.
www.hamradiorepeater.info
